Help us help you. By posting the year, make, model and engine near the beginning of your help request, followed by the symptoms (no start, high idle, misfire etc.) Along with any prevalent Diagnostic Trouble Codes, aka DTCs, other forum members will be able to help you get to a solution more quickly and easily!
dio
- ur882
-
Topic Author
- Offline
- New Member
-
Less
More
- Posts: 3
- Thank you received: 0
6 years 6 months ago #39144
by ur882
dio was created by ur882
1996 ram 3500 v10 gas kids pulled out remote start sniped wires but at the splices. no start ,no spark, this is an older truck so just for g.p. i replaced crank, oil, cam sensors.. for just a bit of a face lift for the eng. there was one wire goining to coil pack that also got cut from under dash somewere. new batt. power to starter is good jumped starter ,crankes well. i know its relayes r good have not by past were do i start .watched many of your vids.
Please Log in or Create an account to join the conversation.
- Tutti57
-
- Offline
- Platinum Member
-
Less
More
- Posts: 1100
- Thank you received: 254
6 years 6 months ago - 6 years 6 months ago #39146
by Tutti57
Replied by Tutti57 on topic Re:dio
Did it run before the remote start was taken out it you don't know?
Have you check to see if it's missing spark, fuel, or both?
Any codes?
Nissan Technician
Have you check to see if it's missing spark, fuel, or both?
Any codes?
Nissan Technician
Last edit: 6 years 6 months ago by Tutti57.
Please Log in or Create an account to join the conversation.
- ur882
-
Topic Author
- Offline
- New Member
-
Less
More
- Posts: 3
- Thank you received: 0
6 years 6 months ago #39158
by ur882
Replied by ur882 on topic Re:dio
it ran when i parked it 4 months ago. checked all wiring visually
Please Log in or Create an account to join the conversation.
- ur882
-
Topic Author
- Offline
- New Member
-
Less
More
- Posts: 3
- Thank you received: 0
6 years 6 months ago #39159
by ur882
Replied by ur882 on topic Re:dio
no crank no start no spark has fuel presure
Please Log in or Create an account to join the conversation.
Time to create page: 0.290 seconds